Full Calibration

Completing a full calibration can remedy several error messages, such as paper-out and ribbon-out errors, that appear on the printer. Doing a full calibration can take up to 15 minutes.

1. To begin a full calibration press the Setup/Exit button on the front of the printer.
2. Press the right arrow button until you get to Media and Ribbon Calibrate.
3. Press the + button.
4. The screen will now say Load Backing.
5. Open up the print head and pull 4 tags through the printer.
6. Peel the tags off and leave the backing connected to the roll.
7. Rewind the roll.
8. Press the + button, the screen will now say Remove Ribbon.
9. To remove the ribbon (ink ribbon) move the ribbon over to the right away from the red light.
10. Press the + button, the screen will say Reload All.
11. Put the ribbon back into place and close the print head.
12. Press the + button and it will send out several tags.
13. You have completed a full calibration.